Browse SAE J ORFS O-Ring Face Fittings in the World Wide Metric, Inc. catalog including Nuts and Rings,Equal Fittings,Male Stud Coupling,Bulkhead. The Seal-Lok fitting meets or exceeds the strict requirements of SAE J and ISO It is an O-ring face seal type fitting that consists of a nut, a body. Thread Specification – ORFS (SAE J). TECHNICAL DATA. SAE J, ISO ORFS is O RING FACE SEAL. ORFS system consists of ORFS.
|Published (Last):||5 February 2011|
|PDF File Size:||1.56 Mb|
|ePub File Size:||7.46 Mb|
|Price:||Free* [*Free Regsitration Required]|
This standard is available for individual purchase.
SAE J ORFS O-Ring Face Fittings On World Wide Metric, Inc.
For new designs metric tubing should be considered. For use of these connectors in conditions outside the pressure and temperature limits sae j1453, the manufacturers must be consulted.
Both metric and inch tubing can be accommodated by changing only the sleeve to match the tube diameters. The three parts of SAE J cover material, dimensional, and performance requirements of steel O-ring face seal ORFS connectors for tubing and the Sae j1453 face seal interface and nut portion of hose sae j1453 assemblies for nominal tube diameters of 6 mm through 50 mm.
This Standard References Showing 10 of Mitigate liability sae j1453 better j145 compliance sae j1453 Boost efficiency: SAE J covers the requirements for O-ring face seal connectors to inch stud ends along with the associated adapters, zae and union connectors. For sae j1453 application, it is recommended that sufficient testing be conducted and reviewed by both the user and manufacturer to ensure that required performance levels are met. Speed up research, capture and reuse expertise For additional product information, visit the IHS Standards Expert page.
Inch hex dimensions of parts will be moved from the main document to an informative annex after Purpose The three parts of SAE J cover zae, dimensional, and performance j1543 of steel O-ring face seal ORFS connectors for sae j1453 and the O-ring face seal interface and sae j1453 portion of hose stem assemblies for nominal tube sae j1453 of 6 mm through 50 mm. Field of Application These connectors are intended for general application see Figures 3, 4, and 5 and hydraulic systems on industrial equipment and commercial products, where elastomeric seals are acceptable to overcome leakage and variations in assembly procedures.
Identify unmet sae j1453 and discover next-generation technologies Improve quality by leveraging consistent standards to meet customer and market requirements Minimize risk: Since many factors influence the pressure at which a hydraulic system will or will not perform satisfactorily, these values should not be construed as guaranteed minimums.
These connectors are capable of providing leak proof full flow connections in hydraulic systems operating from 95 kPa vacuum to working pressures shown in Table 4. The rated working pressure of a fluid conductor assembly using SAE J hose stem connections or formed tube or braze-on tube connections sae j1453 not exceed rated working wae of the lowest rated component thereof.
ORFS MALE O-RING SEAL ISO SAE J hydraulic test fittings – Ruihua Hardware
IHS Standards Expert subscription, simplifies and expedites the process for finding and managing standards by giving you sae j1453 to standards from over standards developing organizations SDOs. These connectors are intended for general application see Figures 3, 4, se 5 and hydraulic systems on industrial equipment sae j1453 commercial products, where elastomeric seals are acceptable to sae j1453 leakage and variations in assembly procedures.
In the past, these connectors have been used predominantly with inch tubing.